FPGA-based low-cost synchronized fiber network for experimental setups in space

verfasst von
Tim Oberschulte, Thijs Wendrich, Holger Blume
Abstract

Custom experiment setups in physics often require control electronics to execute actions and measurements on a small time scale. When further constraints limit the experiment's environment, for example when the experiment is inside a sounding rocket, conventional network systems will not suffice those constraints because of weight, heat or budget limitations. This paper proposes a network architecture with a time resolution of less than 1 ns over a pair of plastic fibers while using low-cost commercial hardware. The plastic fibers in comparison to copper fibers have a low weight and additionally can isolate parts of the setup galvanically. Data rates of 40 Mbit/s enable the network to transfer large amounts of measurements and configuration data over the network. Proof-of-concept implementations of network endpoints and switches on small FPGAs are analyzed in terms of synchronicity, data rate and resource usage. Using commercial parts the resolution of 1 ns is reached with a standard deviation of less than 100 ps. Compared to a copper wire implementation the weight is reduced by about one order of magnitude. With its low weight at a low cost, the network is useful in space or laboratory setups which require high time resolution.

Organisationseinheit(en)
Institut für Quantenoptik
Fachgebiet Architekturen und Systeme
Typ
Artikel
Journal
Journal of Instrumentation
Band
16
ISSN
1748-0221
Publikationsdatum
15.11.2021
Publikationsstatus
Veröffentlicht
Peer-reviewed
Ja
ASJC Scopus Sachgebiete
Instrumentierung, Mathematische Physik
Elektronische Version(en)
https://arxiv.org/abs/2109.11638 (Zugang: Offen)
https://doi.org/10.1088/1748-0221/16/11/p11016 (Zugang: Geschlossen)