Simulation and measurement of the flip chip solder bumps with a Cu-plated plastic core

verfasst von

K. Weide-Zaage, J. Schlobohm, R. T.H. Rongen, F. C. Voogt, R. Roucou

Abstract

With the aim to miniaturize and to reduce the cost, the increasing demand, regarding to advanced 3D-packages as well as high performance applications, accelerates the development of 3D-silicon integrated circuits. The trend to smaller and lighter electronics has highlighted many efforts towards size reduction and increased performance in electronic products. The radio frequency (RF) performances are limited by parasitic effects due to the resistor-inductor-capacitor (RLC) network, between the wire bond connections from the dies to the lead frame. The use of flip-chip bonding technology for very fine pitch packaging allows high integration and limits parasitic inductances. Electromigration (EM) and thermomigration (TM) may have serious reliability issues for fine-pitch Pb-free solder bumps in the flip-chip technology used in consumer electronic products. A possibility to extend the reliability is the use of plastic ball in the solder bumps. Bumps containing a plastic solder balls have an excellent reliability. Using a plastic ball with a low Young modulus, the solder hardness is moderated and the stress on a ball is relaxed. Due to this, the stress does not concentrate on the solder joint which prolongs the lifetime. In this investigation, the thermal-electrical-mechanical coupling of electromigration on bumps containing a plastic solder is studied.

Organisationseinheit(en)

Laboratorium f. Informationstechnologie

Externe Organisation(en)

NXP Semiconductors N.V.

Typ

Artikel

Journal

Microelectronics reliability

Band

54

Seiten

1206-1211

Anzahl der Seiten

6

ISSN

0026-2714

Publikationsdatum

2014

Publikationsstatus

Veröffentlicht

Peer-reviewed

Ja

ASJC Scopus Sachgebiete

Elektronische, optische und magnetische Materialien, Atom- und Molekularphysik sowie Optik, Sicherheit, Risiko, Zuverlässigkeit und Qualität, Physik der kondensierten Materie, Oberflächen, Beschichtungen und Folien, Elektrotechnik und Elektronik

Elektronische Version(en)

https://doi.org/10.1016/j.microrel.2014.02.021 (Zugang: Geschlossen)